- Update to version 2.40:
* Objdump has a new command line option --show-all-symbols which will make it
display all symbols that match a given address when disassembling. (Normally
only the first symbol that matches an address is shown).
* Add --enable-colored-disassembly configure time option to enable colored
disassembly output by default, if the output device is a terminal. Note,
this configure option is disabled by default.
* DCO signed contributions are now accepted.
* objcopy --decompress-debug-sections now supports zstd compressed debug
sections. The new option --compress-debug-sections=zstd compresses debug
sections with zstd.
* addr2line and objdump --dwarf now support zstd compressed debug sections.
* The dlltool program now accepts --deterministic-libraries and
--non-deterministic-libraries as command line options to control whether or
not it generates deterministic output libraries. If neither of these options
are used the default is whatever was set when the binutils were configured.
* readelf and objdump now have a newly added option --sframe which dumps the
SFrame section.
* Add support for Intel RAO-INT instructions.
* Add support for Intel AVX-NE-CONVERT instructions.
* Add support for Intel MSRLIST instructions.
* Add support for Intel WRMSRNS instructions.
* Add support for Intel CMPccXADD instructions.
* Add support for Intel AVX-VNNI-INT8 instructions.
* Add support for Intel AVX-IFMA instructions.
* Add support for Intel PREFETCHI instructions.
* Add support for Intel AMX-FP16 instructions.
* gas now supports --compress-debug-sections=zstd to compress
debug sections with zstd.
* Add --enable-default-compressed-debug-sections-algorithm={zlib,zstd}