Overview
Request 795483 accepted
PrusaSlicer takes 3D models (STL, OBJ, AMF) and converts them into G-code instructions for FFF printers or PNG layers for mSLA 3D printers. It's compatible with any modern printer based on the RepRap toolchain, including all those based on the Marlin, Prusa, Sprinter and Repetier firmware. It also works with Mach3, LinuxCNC and Machinekit controllers.
Resubmitting in the hope that all bots and maintainers pick it up this time. The old request was stale for almost a month.
- Created by bnavigator
- In state accepted
Request History
bnavigator created request
PrusaSlicer takes 3D models (STL, OBJ, AMF) and converts them into G-code instructions for FFF printers or PNG layers for mSLA 3D printers. It's compatible with any modern printer based on the RepRap toolchain, including all those based on the Marlin, Prusa, Sprinter and Repetier firmware. It also works with Mach3, LinuxCNC and Machinekit controllers.
Resubmitting in the hope that all bots and maintainers pick it up this time. The old request was stale for almost a month.
factory-auto added opensuse-review-team as a reviewer
Please review sources
factory-auto accepted review
Check script succeeded
dimstar_suse added openSUSE:Factory:Staging:adi:28 as a reviewer
Being evaluated by staging project "openSUSE:Factory:Staging:adi:28"
dimstar_suse accepted review
Picked "openSUSE:Factory:Staging:adi:28"
licensedigger accepted review
ok
dimstar accepted review
dimstar_suse accepted review
Staging Project openSUSE:Factory:Staging:adi:28 got accepted.
dimstar_suse approved review
Staging Project openSUSE:Factory:Staging:adi:28 got accepted.
dimstar_suse accepted request
Staging Project openSUSE:Factory:Staging:adi:28 got accepted.