- Update to version 4.5.5 (2023-04-05)
* Add park to rotorez.c
* Fix rig power on/off from rigctl cmd line and rigctld
* Enable async mode by default to prevent WSJT-X crash on IC9700
with transceive on
* Fix IC7610 get_powerstat to disable it -- cannot read power status
* Fix K3 K22 command error for remote operations
* Fix Gemini DX1200 gemini_set_level
* Fix async I/O to not call flush
* Change EX startup commands for Yaesu rigs to allow
errors...Win4Yaesu not recognizing EX commands
* Fix jst145 set_freq and get_freq
* Restore tcflush as some odd behavior was seen that tclush fixes
* Fix XG3 operations
* Separate the validation cmd in newcat.c to allow rig
post_write_delay to be in effect
* Increase post_write to 20ms for FT710
* Add attenuator level control for TS890
* Update SMeter/SWR tables for TS890
* Add fix for TMD700
* Improve FT-857 get_vfo response when error occurs
* Allow FT-857 to use cached vfo on get_vfo when error
occurs reading EEPROM
* Fix FTDX10 FT710 set_level AF
* Fix FT-450D detection
* Fix VFO A/B swapping for gpredict -- hopefully better
behavior for VFO swapping rigs. Should avoid setting RX freq
while TX and avoid TX freq while RX
* Fix QRP QDX PTT to new TQ command due to firmware changes
* Remove EX103 check for FTDX5000
* Fix K3/K3S VFOB setting of mode/width
* Fix AGC level display in rigctld
* Change FTDX10 to no serial handshake
* Add TS2000 to has_ps exception
* Add FT991 to 60M exception
* Fix get_powerstat bad call in rigctl_parse.c
* Really fix CM108 ptt_bitnum usage
* Fix Elecraft power2mW precision/accuracy
* Fix power on/off/on for Icom rigs with rigctld power_on=0