- Update to 2.7.4
* Objects from 3MFs generated by BambuStudio now retain
multimaterial painting when loaded. BambuStudio saves the data
under a changed name, but because both the location and meaning
are the same, PrusaSlicer now tries to load the data under the
new name when it fails to find the attribute that PrusaSlicer
has always used. #12502
* Fix: Downloading files from Printables did not work correctly
(#12521).
- Fixes in 2.7.3
## Bug fixes with respect to 2.7.3-beta1
* Removed negligible deretractions sometimes emitted into the
G-code after the recently introduced spiral vase mode
improvements. While they did not present actual issues with the
print, they were confusingly shown in the G-code preview.
## Bug fixes with respect to 2.7.3-alpha1
* The z offset configuration option was not correctly accounted
for when doing the last filament unload above the wipe tower.
* Fixed crash when importing a specific config bundle while in
SLA mode.
* Linux specific: When changing active profile using the dropdown
in the right panel, the dropdown would stay open when Unsaved
Changes dialog was shown.
* The improvements of spiral vase mode handling introduced in the
previous alpha did not work correctly with absolute extruder
addressing (#2841 (comment)). They are now only applied with
relative extruder addressing, otherwise it falls back to the
old behaviour.
* After performing a toolchange on the wipe tower, a G-code to
set layer z is now always emitted. This is to make sure that