- update to version 1.4.3
cwio accu_sleep
* replace milliSleep with new accu_sleep function
* change activated state of configuration items based on
port selection
* change loop timing to use global accu_sleep
A2B freq only
* add shift-click to A->B button to transfer only
frequency from vfoA to vfoB
* add control-click to A->B button to transfer only
frequency for vfoB to vfoA
vfo adjust
* change increment to fractional values
start/exit set clock
* add user configurable commands on program
. start - immediately after normal start up
. exit - immediately after normal exit
* add time sychronization if supported by xcvr
. xcvr clock synchronized to PC clock on next minute
rollover, to nearest 50 msec.
. implemented for these transceiver:
- ic7100, ic7300, ic7600, ic7610, ic7700, ic7800, ic7851
- FT991, FT991A, FTdx10, FTdx101D, FTdx101MP
FT1200:time only
- TS990
. corrected deactivated controls on some supported xcvrs
TX500
* Add Lab599 TX500 transceiver
cw generator
* update to timing intervals for CW generator
ftdx101d
* fix table lookups for bandwidth
FTdx10
* add as independent transceiver backend
. shares many identical CAT commands to FTdx101D
FT1000MP
* correct read vfo A/B conversion logic
cw invert
* allow user to specify DTR/RTS either normal (+) or
inverted(-) signaling.
Power control
* change to floating point control to allow for
fractional changes in power level, i.e. 0.1 W / step
elad
* Add ELAD FDM-DUO qrp transceiver
g90 cw/power/swr
* set CW/CWR tuning sense
* update power/swr methods
K3 power level
* add OM; read for power level min/max/step initialization
Disable Polling
* USE to test various comms issues between flrig and transceiver
. allow user to disable polling
. allow user to disable xmlrpc server
Transmit meters
* FT991A reported as not showing power out during transmit cycle
cmedia/serial port
* allow both serial port and cmedia devices to be initialized
during startup
K3/KX3/KXPA metering
* correct smeter conversion
* read KX3 power out when KXPA is in standby mode
* Add code to read SWR from KXPA if active
. note: the KXPA100 programmers guide
* Add get trace for KXPA swr reads
IC7851/9610/9700
* Change get/set vfoA/B to use x25, x26 command strings
* correct set/get bandwidth by mode/data/filter
KX3 ptt/if-shift
* add get_PTT
* add reset IF shift control based on current mode
* add has_ptt_control as test for get_PTT call
* poll for change in KXPA presence with poll of
power level setting. Perform test during both Rx and Tx status
kx3_options
* use GET OPTIONS to discover KXPA100 presence
kx3 extras
* add programmed support for KXPA